- HOME PAGE
- Blog Owner Bio
- Convert 4 cylinder Mustang to V8
- 1979 Ford Mustang 4 cylinder to V8 Brake conversio...
- Mustang Parts Car Demolition
- Mustang Parts Car Demolition Continued
- Mustang Radiator Core Support Removal and Installation
- Painting Engine Compartment
- Bro's 1988 GT Mustang
- Mustang Engine Work
- Mustang Roof and Rear Quarters sectioning
- Mustang Floor Pan Replacement
- Mustang UNDERCOATING
- Bend fuel line like a pro
- Rear Seat and Trunk Patching and Repair
- Time Lapse Vids
- 1G to 3G Alternator Conversion
- Subframe Connector Install
- Power Steering Cooler for Autocross Competitions
- Plastic Welding Dash Repair
- Door Lock Replacement
- Reset Odometer Miles
- More Mustang Rust Repair
- M81 McLaren Research "Rarest Mustang Ever"
Wednesday, May 24, 2017
How to Plastic Weld Repair a 1979 Ford Mustang Dash
I knew that there was a few places to repair on the dash when I was in the salvage yard. The glove box had it's hinge rusted solid and some one tried forcing it and cracked the middle lower part of dash. The speaker areas on both sides were cracked, so I went to Harbor Freight and bought a plastic welding iron kit. Cost around $17.00 comes with plastic and wire mesh as well.
Inspecting the damage. You will need to remove the metal reinforcements from the dash hull to do the plastic welding reinforcement work.
Anything that is in the way will need to be removed. Notice screws on the side and bottom hold the metal dash reinforcement and car mounting brackets to the dash hull. There were needing to be removed for the glove box area to be repaired.
Ducting needs to be removed as well and you will find additional screw hidden.
Once brackets and reinforcements are removed can further inspect the area.
You'll want to clean around the area with rubbing alcohol and wire brush.
Carefully hold things together and then lightly press on crack to stitch things together, so that things are held into proper placement.
Next you will want to cut some wire mesh and form it into a reinforcement to strengthen the area.
Use the iron to carefully melt the mesh into the plastic area then use provided additional plastic to add additional structure around the cracked area.
Some areas you can't follow all the way in due to space constraints I recommend coming back later with epoxy and fixing and filling in additional structure.
You will notice once the mesh is in place the structure is much more rigid. You should do this for all cracks.
Stitch with the iron. Dont' wory about cosmetics on the top where speakers go. Keep in mind that this area will be covered by the dash pad. More care should be taken in the area around the glove box, so be careful not to make things worse.
This is a tedious project and you need to be careful with the hot iron at all time so that you don't damage any thing. The Iron is so hot that it would cut through the dash like it's butter, to take great care.
The driver side speaker spot had multiple spider cracks that aren't easily visible. However, I decided to add the wire mesh on both sides and reinforce. This made the area very strong.
Slowly working in the extra reinforcement.
This is the bottom side of the speaker hole on driver side.
I plan on washing the whole dash and repainting it black. to match my original, which is still in the car. I didn't get it pulled yet.